Nozzle Holder

Availability: In stock


A sleeve type coupling that is secured to the hose with wood screws and have the same features as the sandblast hose end. The exception is that the hose end of the nozzle holder is NPT threaded to accept the sandblasting nozzle.



Sandblast Nozzle Holder General Uses

Design of Sandblast Nozzle holder is to slip over sandblast hose and to be fastened with screws. Such an external coupling prevents restriction of flow and prevents coupling wear out from the high velocity of sand.


Since these fittings attach to the outside of the hose, use them only with sandblast hose. Therefore take special care not to let the screws penetrate the hose tube.


Use these fittings  with sandblast hose only!


•  We supply Sandblast Quick Couplings with screws.


• Cut ends of hose square to fit snug against metal end.

• Holding hose tight to end of fitting, insert screws and turn in full, putting screw 180° from first to ensure best centering.

• After all screws have been placed, finally check tube opposite screws to be sure screws have not penetrated completely through.

• On quick couplings, insert safety clips.


There are no reviews yet.

Be the first to review “Nozzle Holder”

Your email address will not be published. Required fields are marked *

Open chat